ASN Wikibase Occurrence # 137989
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can
submit corrected information.
Date: | Wednesday 17 August 2011 |
Time: | 08:05 |
Type: | Cessna 310Q |
Owner/operator: | Private |
Registration: | N444YM |
MSN: | 310Q0958 |
Year of manufacture: | 1973 |
Total airframe hrs: | 3382 hours |
Engine model: | Continental IO-470 |
Fatalities: | Fatalities: 1 / Occupants: 1 |
Aircraft damage: | Substantial |
Category: | Accident |
Location: | Near Tupelo Regional Airport - KTUP, MS -
United States of America
|
Phase: | Initial climb |
Nature: | Private |
Departure airport: | Tupelo, MS (TUP) |
Destination airport: | Hamilton, AL (HAB) |
Investigating agency: | NTSB |
Confidence Rating: | Accident investigation report completed and information captured |
Narrative:The airplane had just undergone an annual inspection, at which time the left engine’s number two cylinder was replaced. In order to facilitate the cylinder replacement, the B-nut attaching the fuel supply hose to the engine’s manifold valve was removed and reinstalled. A postmaintenance engine ground run was performed, and no discrepancies were noted.
The airplane was cleared to depart from runway 36 with an easterly departure. Witnesses observed the airplane roll down the runway, liftoff, and at an estimated altitude of 300 to 500 feet above the runway, about mid-field, witnesses observed the airplane turn to the left on a west heading and descend. Witnesses heard a loss of engine power just before the turn. The airplane impacted the adjacent main road, and all three of the landing gear separated. The airplane struck a vehicle and a tree before its nose section impacted the base of a 3-foot diameter tree in the front yard of a house and then came to a stop. Postaccident propeller examination revealed that both propellers were in a low pitch position; the right propeller impacted while operating at high power, and the left was operating with low power or was windmilling at time of impact.
The on-site wreckage examination found that the B-nut connecting the fuel supply hose to the manifold valve on top of the left engine had backed off about a quarter turn. The B-nut was tightened, and both engines were test run after the accident; no abnormalities that would have prevented normal operation were found. Both engines produced production-rated power. After completion of the left engine test run, the B-nut between the fuel supply hose and the manifold valve was set at finger-tight torque. A wire was attached to loosen the B-nut during the engine run, and a stop was in place to limit the rotation. The engine was started and set at full throttle and the B-nut was loosened to slightly over a quarter turn. When the B-nut was loosened, the engine immediately lost power. It is likely that the B-nut had been tightened sufficiently to maintain torque during the ground run; however, the vibration of extended engine operation during takeoff led the B-nut to back off, resulting in the loss of power in the left engine.
From the position where the witnesses reported hearing the airplane lose engine power, about half the runway (or about 3,200 feet) remained. In addition, an open field was located past the departure end of that runway. However, the airplane turned left after the loss of engine power, which was contrary to the departure instructions and contrary to the safest option for an emergency landing (the remaining runway or the open field). Further, the propeller blades were in the low pitch position, indicating that the pilot didn’t perform the engine failure checklist, which stated that the propeller should be feathered. Thus, it is likely that the pilot was delayed in his reaction to the sudden loss of thrust from the left engine and could not maintain airspeed or straight ahead flight.
Probable Cause: The pilot’s delayed reaction in performing the engine failure procedures and his failure to maintain adequate airspeed, which resulted in a loss of airplane control. Contributing to the accident was maintenance personnel’s improper torquing of the B-nut between the fuel supply hose and the manifold valve.
Accident investigation:
|
| |
Investigating agency: | NTSB |
Report number: | ERA11FA458 |
Status: | Investigation completed |
Duration: | 1 year and 7 months |
Download report: | Final report |
|
Sources:
NTSB
Location
Revision history:
Date/time | Contributor | Updates |
17-Aug-2011 08:42 |
gerard57 |
Added |
17-Aug-2011 12:26 |
gerard57 |
Updated [Operator, Source] |
17-Aug-2011 12:31 |
78Delta |
Updated [Registration, Cn, Operator] |
18-Aug-2011 03:09 |
RobertMB |
Updated [Time, Aircraft type, Operator, Other fatalities, Location, Phase, Departure airport, Source, Narrative] |
21-Dec-2016 19:26 |
ASN Update Bot |
Updated [Time, Damage, Category, Investigating agency] |
27-Nov-2017 17:05 |
ASN Update Bot |
Updated [Operator, Other fatalities, Departure airport, Destination airport, Source, Narrative] |
The Aviation Safety Network is an exclusive service provided by:
CONNECT WITH US:
©2024 Flight Safety Foundation