ASN Wikibase Occurrence # 145401
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can submit corrected information.
| Date: | Wednesday 2 May 2012 |
| Time: | 11:40 |
| Type: |  Hughes 269C |
| Owner/operator: | Canyon State Aero |
| Registration: | N380TL |
| MSN: | 680694 |
| Year of manufacture: | 1978 |
| Total airframe hrs: | 1582 hours |
| Engine model: | Lycoming HIO-360-DIA |
| Fatalities: | Fatalities: 0 / Occupants: 2 |
| Aircraft damage: | Substantial |
| Category: | Accident |
| Location: | East of St. Rte. 51 and Indian School Road, Phoenix, AZ -
 United States of America
|
| Phase: | Manoeuvring (airshow, firefighting, ag.ops.) |
| Nature: | Executive |
| Departure airport: | Phoenix, AZ (DVT) |
| Phoenix, AZ (DVT) | |
| Investigating agency: | NTSB |
| Confidence Rating: |  Accident investigation report completed and information captured |
When the pilot was about 2 minutes from his destination at an altitude of about 500 feet above ground level, he sensed a vibration through the back of his seat and in the anti-torque pedals. The vibration was followed by a right yaw that the pilot could not correct with a pedal input. As the pilot attempted to maintain level flight, he heard a "metallic clunking" behind him. He looked back and saw what he described as the tail rotor losing rotor speed. The pilot maintained forward flight by countering the right yaw with left cyclic input while he located a cul-de-sac in a residential neighborhood in which to land. The pilot entered an autorotation, and during the descent, the helicopter impacted the roof of a house and an adjacent brick wall. Witnesses reported that the helicopter didn't “sound right,” that the engine was sputtering, and that the engine power appeared to be increasing and decreasing. The helicopter was observed rocking and teetering before nose-diving toward the ground. After the helicopter impacted the ground, the engine continued to run, and the tail rotor continued to spin.
A postaccident investigation revealed that the main transmission pinion had fractured and separated through the threads that retained the aft pinion nut. Because the aft pinion nut maintained the position of the splined sleeve that drove the tail rotor drive shaft, the separation of the pinion allowed the sleeve to wobble as it turned and to move aft, partially disengaging its external splines from the internal splines in the tail rotor drive shaft. The sleeve’s splines began to grind against the drive shaft’s splines, and the resulting material loss on the splines reduced the engagement between the parts to the point where a loss of tail rotor drive occurred. It is likely that enough residual contact between the damaged splines remained to keep the tail rotor spinning (as observed after impact) but was not sufficient to deliver power to the tail rotor.
Examination of the pinion fracture surfaces determined that the pinion failure was due to a fatigue crack that initiated in a thread root and propagated through about 75 percent of the pinion’s cross-section before the remaining material succumbed to overstress conditions. No indication of material deficiencies, such as inclusions, voids, or pits, were found at the crack initiation site. According to the helicopter’s maintenance records, the pinion had been in service for 1,584.4 hours, and on the day before the accident, a 100-hour inspection had been performed in accordance with the helicopter manufacturer’s instructions. These instructions included a procedure for checking the torque of the aft pinion nut, and a co-owner of the helicopter reported that he observed the mechanic perform the torque check. It is likely that the fatigue crack was not large enough to be detected during the inspection and then propagated to the point of failure during the accident flight.
Probable Cause: A loss of tail rotor drive due to a fatigue failure of the main transmission pinion, which resulted in a loss of directional control during cruise flight.
Accident investigation:
 |
|
Sources:
NTSB
Location
Revision history:
| Date/time | Contributor | Updates |
|---|---|---|
| 03-May-2012 08:35 | Geno | Added |
| 03-May-2012 08:40 | Geno | Updated [Time, Source] |
| 08-May-2012 10:01 | Geno | Updated [Time, Phase, Nature, Departure airport, Destination airport, Source, Narrative] |
| 21-Dec-2016 19:28 | ASN Update Bot | Updated [Time, Damage, Category, Investigating agency] |
| 27-Nov-2017 20:42 | ASN Update Bot | Updated [Operator, Other fatalities, Nature, Departure airport, Destination airport, Source, Narrative] |
Corrections or additions? ... Edit this accident description
The Aviation Safety Network is an exclusive service provided by:
Quick Links:
| ASN Home | Send Correction / Feedback |
| FSF Home | Disclaimer | Copyright |
| Contact Us | Privacy Policy |
| Press / Media |
CONNECT WITH US:
©2024 Flight Safety Foundation