ASN Wikibase Occurrence # 288390
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can
submit corrected information.
Date: | Sunday 27 June 2010 |
Time: | 17:00 LT |
Type: | Lancair IV |
Owner/operator: | Private |
Registration: | N86PB |
MSN: | LIV 154 |
Total airframe hrs: | 560 hours |
Engine model: | Continental IO-550 SERIES |
Fatalities: | Fatalities: 0 / Occupants: 1 |
Aircraft damage: | Substantial |
Category: | Accident |
Location: | Caldwell, Idaho -
United States of America
|
Phase: | Standing |
Nature: | Executive |
Departure airport: | Caldwell Industrial Airport, ID (KEUL) |
Destination airport: | La Grande Airport, OR (LGD/KLGD) |
Investigating agency: | NTSB |
Confidence Rating: | Accident investigation report completed and information captured |
Narrative:Several minutes after starting the engine, the pilot noticed an odor in the cockpit, which he thought was similar to that of burning plastic. He could hear the hydraulic pump cycle once, which he thought was unusual. He pulled the hydraulic circuit breaker out and within 30 seconds he observed smoke emanating from the engine area. He shut down the airplane and noticed flames at the bottom of the engine cowl. According to the pilot, the last conditional inspection was completed 6 days prior to the accident, and the airplane accumulated 2 flight hours since that inspection. An examination of the firewall revealed that its right side had a white coloration, which turned to a black soot color on the left side, consistent with the fire originating on the right side of the engine. On the right side of the belly area, near the nose landing gear compartment, a red/pink hydraulic fluid stain started and continued down toward the tail. The stain became small beads of pooling liquid at the low point of the belly, indicating a hydraulic leak. Above the stain, on the right side of the engine firewall, were two hydraulic fittings where hoses connected to either side of the nose landing gear actuator. Based on this evidence, it is likely that the fitting on the lower hydraulic line was not properly tightened, which allowed it to back off due to normal engine vibration, resulting in the line loosening during engine start. Pressurized hydraulic fluid then sprayed onto the right exhaust shroud and ignited.
Probable Cause: The failure of maintenance personnel to ensure that a hydraulic line fitting was adequately secured during a conditional inspection, which resulted in a leak and subsequent on-ground fire.
Accident investigation:
|
| |
Investigating agency: | NTSB |
Report number: | WPR10LA319 |
Status: | Investigation completed |
Duration: | 9 months |
Download report: | Final report |
|
Sources:
NTSB WPR10LA319
Location
Revision history:
Date/time | Contributor | Updates |
04-Oct-2022 21:58 |
ASN Update Bot |
Added |
The Aviation Safety Network is an exclusive service provided by:
CONNECT WITH US:
©2024 Flight Safety Foundation