ASN Wikibase Occurrence # 354959
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can
submit corrected information.
Date: | Tuesday 9 December 1997 |
Time: | 17:00 LT |
Type: | Cessna 150J |
Owner/operator: | Alternate Air Flying Club |
Registration: | N51369 |
MSN: | 15069956 |
Total airframe hrs: | 3351 hours |
Engine model: | Continental O-200-A |
Fatalities: | Fatalities: 0 / Occupants: 2 |
Aircraft damage: | Substantial |
Category: | Accident |
Location: | Silverdale, WA -
United States of America
|
Phase: | Manoeuvring (airshow, firefighting, ag.ops.) |
Nature: | Training |
Departure airport: | Seattle, WA (KBFI) |
Destination airport: | |
Investigating agency: | NTSB |
Confidence Rating: | Accident investigation report completed and information captured |
Narrative:The flight instructor stated that as the student pilot was recovering from the third of a series of power-off stalls, the engine began to run rough. Power was applied smoothly and carburetor heat was turned off. The engine continued to run rough, and after approximately five seconds, the engine quit. The flight instructor took over the controls from the student and attempted to restart the engine. During the second restart attempt, the flight instructor pulled the starter handle, however, the handle separated from the panel. A forced landing was made to a soft field where a successful touchdown was accomplished, but during the landing roll, the nose wheel dug in and the airplane nosed over. During the postaccident inspection, the engine was run to 2500 rpm. The engine operated smoothly, with no discrepancies noted. Both magnetos were checked and found operational. The carburetor heat control was checked and found operational. The engine pull-to-start knob was inspected and it was found to have pulled off the metal shaft that runs through the panel, and the metal shaft had pulled away from the cable that runs to the starter lever.
Probable Cause: Ice accumulation in the carburetor throat. Factors include conditions conducive to serious carburetor icing, an inoperative starter due to a separated pull-to-start knob, and soft terrain at the location of the forced landing.
Accident investigation:
|
| |
Investigating agency: | NTSB |
Report number: | SEA98LA022 |
Status: | Investigation completed |
Duration: | 4 months |
Download report: | Final report |
|
Sources:
NTSB SEA98LA022
Location
Revision history:
Date/time | Contributor | Updates |
12-Mar-2024 06:26 |
ASN Update Bot |
Added |
The Aviation Safety Network is an exclusive service provided by:
CONNECT WITH US:
©2024 Flight Safety Foundation