ASN Wikibase Occurrence # 39045
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can
submit corrected information.
Date: | Sunday 24 May 1998 |
Time: | 06:30 LT |
Type: | Van's RV-8 |
Owner/operator: | Richard Van Grunsven |
Registration: | N58RV |
MSN: | 2 |
Total airframe hrs: | 400 hours |
Engine model: | Lycoming O-320-DIF |
Fatalities: | Fatalities: 2 / Occupants: 2 |
Aircraft damage: | Destroyed |
Category: | Accident |
Location: | Ripley, CA -
United States of America
|
Phase: | En route |
Nature: | Executive |
Departure airport: | Blythe, CA |
Destination airport: | |
Investigating agency: | NTSB |
Confidence Rating: | Accident investigation report completed and information captured |
Narrative:The aircraft, equipped with dual controls, departed for a demonstration flight with the pilot in the front seat and the pilot-rated passenger in the back. A demonstration flight includes only low-G maneuvers. The aircraft, designed for aerobatics, had, since its manufacture, performed aerobatic maneuvers on previous flights. The maximum allowable gross weight for aerobatics is 1,550 pounds. The aircraft weighed an estimated at 1,639 pounds at the time of the accident. An agricultural pilot reported seeing the aircraft in a shallow climb about 500 feet agl. An eyewitness, over a mile from the accident site, heard an engine surging and looked up. He saw a yellow aircraft flying straight and level, about 1,000 feet agl. As he watched, something fell from the aircraft, which was followed by a loud boom. The aircraft pitched up, nosed over, rolled, entering a spin that continued until impact. The outboard portion of the left wing was found 0.17 miles from the crash site. The main spar had evidence of a ductile fracture due to a positive overload. The spar material met design specifications for metal composition and hardness. There was no evidence of fatigue or corrosion. The outboard section of the left wing did not exhibit any evidence of aeroelastic divergence. A flutter test showed the aircraft design was free from flutter to speeds above its design envelope. Wing load testing showed the wing design was able to support a limit load, 6 g's. The wing also supported an ultimate load, 9 g's, for 3 seconds without failure. The Engine Management System nonvolatile memory readout provided data points equivalent to 191 mph in level flight. Maneuvering speed under the same conditions was 142 mph.
Probable Cause: the intentional or unintentional sudden application of aft elevator control by an undetermined aircraft occupant that exceeded the design stress limits of the aircraft. The aircraft gross weight, which exceeded the maximum allowable for aerobatics, and airspeed, which exceeded the maximum maneuvering speed for the weight, were factors in this accident.
Accident investigation:
|
| |
Investigating agency: | NTSB |
Report number: | LAX98FA171 |
Status: | Investigation completed |
Duration: | 1 year and 10 months |
Download report: | Final report |
|
Sources:
NTSB LAX98FA171
Location
Revision history:
Date/time | Contributor | Updates |
24-Oct-2008 10:30 |
ASN archive |
Added |
05-Nov-2016 20:52 |
junior sjc |
Updated [Operator, Phase, Nature, Narrative] |
21-Dec-2016 19:23 |
ASN Update Bot |
Updated [Time, Damage, Category, Investigating agency] |
16-Apr-2018 05:59 |
junior sjc |
Updated [Phase, Departure airport] |
07-Apr-2024 12:15 |
ASN Update Bot |
Updated [Time, Operator, Other fatalities, Phase, Nature, Departure airport, Source, Narrative, Category, Accident report] |
The Aviation Safety Network is an exclusive service provided by:
CONNECT WITH US:
©2024 Flight Safety Foundation