ASN Wikibase Occurrence # 324231
Date: | Thursday 3 April 1997 |
Time: | 19:55 |
Type: | Cessna 650 Citation III |
Owner/operator: | Mercury Communications |
Registration: | N553AC |
MSN: | 650-0198 |
Year of manufacture: | 1990 |
Total airframe hrs: | 2128 hours |
Engine model: | Garrett TFE-731 |
Fatalities: | Fatalities: 0 / Occupants: 3 |
Aircraft damage: | Substantial, repaired |
Category: | Accident |
Location: | Buffalo-Greater Buffalo International Airport, NY (BUF) -
United States of America
|
Phase: | Approach |
Nature: | Executive |
Departure airport: | Wellsville Municipal Airport, NY (ELZ/KELZ) |
Destination airport: | Buffalo-Greater Buffalo International Airport, NY (BUF/KBUF) |
Investigating agency: | NTSB |
Confidence Rating: | Accident investigation report completed and information captured |
Narrative:A Cessna 650 Citation III, N553AC, was substantially damaged by a fire while on approach to Buffalo, New York. The two certificated airline transport rated pilots, and one passenger were not injured.
The flight originated in Coudersport, Pennsylvania, with two passengers onboard. An intermediate stop was made at Wellsville, New York, and one passenger exited the airplane. The flight then continued on to Buffalo.
While being vectored for the final approach in visual conditions, at night, the flight crew lost radio contact with the control tower and smelled smoke aboard the airplane. They continued the approach and landed, and after reaching their parking space, were notified by ground personnel of flames penetrating the top of the aft fuselage between the engines. The fire was extinguished by airport fire fighting personnel.
Postaccident investigation found a hydraulic return line in the aft equipment bay had evidence of electrical arcing and a small hole through which fluid could escape. An 115-volt electrical line used to heat the horizontal stabilizer also had evidence of rubbing on its surface. In addition to the hydraulic fluid, a pressurized fuel line to the APU was damaged by the fire and leaking fuel. A test simulating an electrical line arcing with a leaking hydraulic line resulted in a fire during each of the three tests. The production standards that Cessna used did not specify a minimum space between electrical lines and flammable fluid lines. The FAA had certified the airplane without requiring Cessna to specify a minimum spacing between electrical lines and flammable fluid lines.
PROBABLE CAUSE: "A combination hydraulic fluid and fuel-fed fire which originated from electrical arcing, due to the lack of an adequate production standard from Cessna for the separation of flammable fluid lines and electrical lines. A factor was the lack of oversight from the FAA, which allowed Cessna to space the flammable fluid lines and electrical lines at too close a position."
Accident investigation:
|
| |
Investigating agency: | NTSB |
Report number: | NYC97LA068 |
Status: | Investigation completed |
Duration: | 1 year |
Download report: | Final report |
|
Sources:
NTSB
Revision history:
Date/time | Contributor | Updates |
The Aviation Safety Network is an exclusive service provided by:
CONNECT WITH US:
©2024 Flight Safety Foundation