Runway excursion Accident British Aerospace BAe-125-700A N703TS,
ASN logo
ASN Wikibase Occurrence # 322443
 

Date:Tuesday 8 March 2005
Time:21:50
Type:Silhouette image of generic H25B model; specific model in this crash may look slightly different    
British Aerospace BAe-125-700A
Owner/operator:Hawker 700 Holding Company LLC
Registration: N703TS
MSN: 257031
Year of manufacture:1978
Fatalities:Fatalities: 0 / Occupants: 4
Aircraft damage: Minor, written off
Category:Accident
Location:Teterboro Airport, NJ (TEB) -   United States of America
Phase: Landing
Nature:Private
Departure airport:Columbus-Port Columbus International Airport, OH (CMH/KCMH)
Destination airport:Teterboro Airport, NJ (TEB/KTEB)
Investigating agency: NTSB
Confidence Rating: Accident investigation report completed and information captured
Narrative:
A BAe-125-700A, N703TS, sustained minor damage during an overrun, while landing at Teterboro Airport (TEB), New Jersey. The two pilots and two passengers were not injured. Night visual meteorological conditions prevailed for the flight that departed Columbus-Port Columbus International Airport, Ohio.
Prior to the day of the incident, the pilot and copilot had not flown together. In addition, the copilot spoke broken English. The copilot obtained the current ATIS information about 150 miles from the destination airport. Although the ATIS information reported thin slush on all surfaces, the captain had not asked about runway conditions, and the copilot did not relay the information regarding runway conditions.
The flightcrew continued the approach in moderate to severe turbulence, and performed pre-landing checks. Due to the turbulence, the flightcrew missed several radio transmissions, including the aircraft ahead them that reported a go-around, and later reported good braking action. The incident airplane turned onto final approach for runway 01; a 7,000-foot-long, 150-foot-wide, asphalt runway. During the final approach, the landing gear was down and flaps were in the 25-degree extended position. Air Traffic Control (ATC) relayed the good braking action report to the incident flightcrew, based upon the previous arrival aircraft. However, the previous arrival aircraft was equipped with thrust reversers, and the incident airplane was not. ATC also provided two wind checks to the incident airplane while on final approach. The wind checks were reported as 340 degrees at 15 knots, and 340 degrees at 20 knots, respectively. The pilot reported that due to the wind, he flew the final approach without full flaps, at Vref plus 20 (139 knots), and slowed to 134 knots over the runway threshold.
After touchdown the airplane failed to stop on the runway and overran.
The airplane came to rest approximately 230 feet beyond the departure end of runway 1.

PROBABLE CAUSE: "The pilot in command's inadequate in-flight planning, which resulted in an overrun landing on a contaminated runway. Factors were inadequate crew coordination, gusty winds, and a slush covered runway. "

Accident investigation:
cover
  
Investigating agency: NTSB
Report number: NYC05IA055
Status: Investigation completed
Duration: 1 year
Download report: Final report

Sources:

NTSB

Location

Images:


photo (c) via Werner Fischdick; Zürich-Kloten Airport (ZRH/LSZH); June 1996

Revision history:

Date/timeContributorUpdates

The Aviation Safety Network is an exclusive service provided by:
Quick Links:

CONNECT WITH US: FSF on social media FSF Facebook FSF Twitter FSF Youtube FSF LinkedIn FSF Instagram

©2024 Flight Safety Foundation

1920 Ballenger Av, 4th Fl.
Alexandria, Virginia 22314
www.FlightSafety.org