Accident Cessna 170B N1296D,
ASN logo
ASN Wikibase Occurrence # 175744
 
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information. If you feel this information is incomplete or incorrect, you can submit corrected information.

Date:Tuesday 28 April 2015
Time:11:45
Type:Silhouette image of generic C170 model; specific model in this crash may look slightly different    
Cessna 170B
Owner/operator:Private
Registration: N1296D
MSN: 25424
Year of manufacture:1958
Total airframe hrs:3740 hours
Engine model:Lycoming O-360-A1A
Fatalities:Fatalities: 0 / Occupants: 1
Aircraft damage: Substantial
Category:Accident
Location:South of Grand Mounds, WA -   United States of America
Phase: Landing
Nature:Private
Departure airport:Spanaway, WA (3B8)
Destination airport:Chehalis, WA (CLS)
Investigating agency: NTSB
Confidence Rating: Accident investigation report completed and information captured
Narrative:
The airline transport pilot reported that he intended to accomplish the engine manufacturer-recommended break-in procedures after repair work was completed while he was en route to another airport to fuel the airplane. The repair work had required that the fuel tanks be drained. Upon completion of the work, the recovered fuel was put in the left fuel tank. The pilot reported that he did not have an exact measurement of fuel but that he estimated that it was about 15 gallons. He also added about 6 1/4 gallons of fuel to the right fuel tank as a backup reserve. The pilot took off with the fuel selector valve (FSV) in the “left” tank position. During the climb to cruise flight, about 2,000 ft above ground level, the airplane experienced a loss of engine power. The pilot’s attempts to restart the engine were unsuccessful. During the descent, the pilot switched the fuel selector to the “both” position; however, the engine would not restart. The pilot subsequently conducted a forced landing in a field; he pulled the airplane’s nose up to clear some tall trees, which resulted in a stall and a subsequent hard landing in the field. 
Postaccident examination of the wreckage revealed that the FSV was properly installed but that the selector handle was slightly right of the forward, or the “both,” position. Further examination of the FSV handle revealed that it was incorrectly indexed to the drive shaft that coupled the handle to the FSV, which allowed the handle to be installed 180 degrees from its correct position. The observed handle orientation resulted in the FSV being closed (or off) when the FSV handle was in the “both” position, right when in the “left” position, and left when in the “right” position. The FSV was verified to be open when positioned in all three feed positions, and closed when positioned to “off.”
The FSV handle had a hole drilled in it at manufacture that was angled to prevent incorrect orientation of the handle. Another hole was observed drilled through the operating arm and handle, which allowed for the incorrect installation of the handle. The investigation could not determine when this hole was drilled.
The pilot reported that, during takeoff, he believed that the fuel selector was positioned to the fuller left tank; however, due to the incorrect indexing to the drive shaft that coupled the handle to the FSV, the fuel selector was actually positioned and drawing fuel from the reserve right fuel tank, and the fuel in that tank was subsequently exhausted, which resulted in the loss of engine power. When the pilot positioned the fuel selector to the “both” position during the emergency procedures, the fuel selector valve was actually in the “off” position. The Pilot’s Operating Handbook specified that the FSV should be in the “both” position during takeoff.



Probable Cause: Maintenance personnel’s incorrect installation of the fuel selector valvehandle, which resulted in fuel starvation, a loss of engine power, and a forced hard landing. Contributing to the accident was the pilot's failure to follow the manufacturer's checklist.

Accident investigation:
cover
  
Investigating agency: NTSB
Report number: WPR15LA153
Status: Investigation completed
Duration:
Download report: Final report

Sources:

NTSB
FAA register: http://registry.faa.gov/aircraftinquiry/NNum_Results.aspx?NNumbertxt=1296D

Location

Revision history:

Date/timeContributorUpdates
29-Apr-2015 01:26 Geno Added
29-Apr-2015 15:32 Geno Updated [Registration, Cn, Operator, Source]
29-Apr-2015 15:39 Geno Updated [Location, Narrative]
21-Dec-2016 19:30 ASN Update Bot Updated [Time, Damage, Category, Investigating agency]
01-Dec-2017 13:01 ASN Update Bot Updated [Other fatalities, Nature, Departure airport, Destination airport, Source, Narrative]

Corrections or additions? ... Edit this accident description

The Aviation Safety Network is an exclusive service provided by:
Quick Links:

CONNECT WITH US: FSF on social media FSF Facebook FSF Twitter FSF Youtube FSF LinkedIn FSF Instagram

©2024 Flight Safety Foundation

1920 Ballenger Av, 4th Fl.
Alexandria, Virginia 22314
www.FlightSafety.org