ASN Wikibase Occurrence # 188121
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can
submit corrected information.
Date: | Friday 10 June 2016 |
Time: | 15:20 |
Type: | Cessna 172S Skyhawk |
Owner/operator: | Air America Flight Center LLC |
Registration: | N21767 |
MSN: | 172S9635 |
Year of manufacture: | 2004 |
Total airframe hrs: | 7416 hours |
Engine model: | Lycoming IO-360-L2A |
Fatalities: | Fatalities: 0 / Occupants: 2 |
Aircraft damage: | Substantial |
Category: | Accident |
Location: | Deming Municipal Airport (KDMN), Deming, NM -
United States of America
|
Phase: | Take off |
Nature: | Executive |
Departure airport: | Deming, NM (DMN) |
Destination airport: | Fort Stockton, TX (FST) |
Investigating agency: | NTSB |
Confidence Rating: | Accident investigation report completed and information captured |
Narrative:The pilots were departing on a cross-country flight. A witness who saw the airplane shortly after takeoff observed the airplane turn back toward the airport, enter a steep right bank, and descend toward the ground. The airplane impacted terrain in a nose-down, right-wing-low attitude. Witnesses on a golf course next to the airport reported that airplane’s engine was running at the time of impact. Neither pilot has any memory of the takeoff or the crash.
Postaccident examination of the airplane revealed no evidence of a preimpact mechanical malfunction or failure of the flight control system or the engine that would have precluded normal operation. The propeller exhibited damage that was consistent with the engine producing power at impact.
Calculations indicate that the airplane was at least 131 lbs over the maximum takeoff weight before the flight. The required takeoff distance and climb performance could not be determined because the airplane’s weight exceeded the pilot operating handbook’s performance chart parameters. However, overall airplane flight performance is reduced as the airplane’s weight increases, resulting in a higher takeoff speed, longer takeoff run, reduced rate and angle of climb, and higher aerodynamic stalling speed. Additionally, the density altitude was about 7,736 ft at the time of the accident, which likely further increased the takeoff distance required for liftoff and adversely affected the engine power available and the climb rate.
Given the available information, the pilots did not maintain adequate control of the airplane during the initial climb after takeoff, which resulted in the airplane exceeding its critical angle of attack and an aerodynamic stall at a low altitude.
Probable Cause: The pilots’ failure to maintain adequate control of the airplane during the initial climb after takeoff, which resulted in the airplane exceeding its critical angle of attack and an aerodynamic stall at a low altitude. Contributing to the accident was the operation of the airplane above its maximum takeoff weight at a high density altitude at the time of the accident.
Accident investigation:
|
| |
Investigating agency: | NTSB |
Report number: | CEN16LA228 |
Status: | Investigation completed |
Duration: | 4 years and 2 months |
Download report: | Final report |
|
Sources:
NTSB
Location
Revision history:
Date/time | Contributor | Updates |
14-Jun-2016 14:19 |
Geno |
Added |
21-Dec-2016 19:30 |
ASN Update Bot |
Updated [Time, Damage, Category, Investigating agency] |
09-Aug-2020 07:24 |
ASN Update Bot |
Updated [Operator, Nature, Departure airport, Destination airport, Source, Narrative, Accident report, ] |
The Aviation Safety Network is an exclusive service provided by:
CONNECT WITH US:
©2024 Flight Safety Foundation