ASN Wikibase Occurrence # 215710
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can
submit corrected information.
Date: | Thursday 25 June 2009 |
Time: | 18:15 |
Type: | Robinson R22 Beta |
Owner/operator: | Lewis and Clark Aviation LLC |
Registration: | N836SH |
MSN: | 3806 |
Year of manufacture: | 2004 |
Total airframe hrs: | 3088 hours |
Engine model: | Lycoming O-360 SERIES |
Fatalities: | Fatalities: 0 / Occupants: 2 |
Aircraft damage: | Substantial |
Category: | Accident |
Location: | Lewiston, ID -
United States of America
|
Phase: | Landing |
Nature: | Training |
Departure airport: | Lewiston–Nez Perce County Airport, ID (LWS/KLWS) |
Destination airport: | Lewiston–Nez Perce County Airport, ID (LWS/KLWS) |
Investigating agency: | NTSB |
Confidence Rating: | Accident investigation report completed and information captured |
Narrative:On June 25, 2009, at 1815 Pacific daylight time, a Robinson R22 Beta, N836SH, lost engine power during flight and landed hard near Lewiston, Idaho. Lewis and Clark Aviation LLC was operating the helicopter under the provisions of 14 Code of Federal Regulations Part 91. The certified flight instructor (CFI) and student pilot were not injured. Visual meteorological conditions prevailed and no flight plan was filed for the instructional flight.
According to the CFI, he and the student were in cruise flight for the student’s first instructional flight. During the flight, the rotor rpm dropped suddenly, and the CFI lowered the collective. Then, he rolled on the throttle but did not get a response. The rpm continued to decrease, and the oil light was illuminated as the helicopter impacted the ground. He attempted to do a run on landing but the skids dug into the ground and the helicopter came to rest on its side with the tail boom separated.
In a phone conversation following the accident, the CFI reported that he had applied full carburettor heat about “a couple of minutes” prior to the loss of power. At the accident site, the carburettor control was found approximately 1 inch out from its stop. It is unknown whether the position of the control had moved during the accident sequence.
The Federal Aviation Administration (FAA) accident coordinator examined the helicopter at the accident site and following its recovery. The linkage for the carburettor heat was continuous and functional. The engine was test run on the accident helicopter. No mechanical anomalies were observed during the examinations.
At 17:56 PDT, the nearest aviation weather reporting facility reported the dew point as 5 degrees Celsius and the temperature as 25 degrees C.
According to the FAA’s icing probability chart, icing conditions existed at glide and cruise power at the time of the accident.
The National Transportation Safety Board determines the probable cause(s) of this accident as follows: A loss of engine power while in cruise flight for undetermined reasons.
Accident investigation:
|
| |
Investigating agency: | NTSB |
Report number: | WPR09LA314 |
Status: | Investigation completed |
Duration: | |
Download report: | Final report |
|
Sources:
NTSB
2. FAA Registration:
https://registry.faa.gov/aircraftinquiry/NNum_Results.aspx?NNumbertxt=N836SH 3.
http://helihub.com/2009/06/26/26-jun-09-n836sh-robinson-r22-lewiston-us-idaho/ Location
Images:
Photo(c): NTSB
Revision history:
Date/time | Contributor | Updates |
26-Sep-2018 18:39 |
Dr.John Smith |
Added |
16-Aug-2021 07:57 |
harro |
Updated [Date, Source, Accident report] |
26-Feb-2022 00:20 |
Captain Adam |
Updated [Location, Departure airport, Destination airport, Source, Narrative, Photo] |
The Aviation Safety Network is an exclusive service provided by:
CONNECT WITH US:
©2024 Flight Safety Foundation