ASN Wikibase Occurrence # 287894
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can submit corrected information.
| Date: | Thursday 2 December 2010 |
| Time: | 15:22 LT |
| Type: |  Rans S-6ES |
| Owner/operator: | Michael Bowden |
| Registration: | N26PP |
| MSN: | 0792327 |
| Total airframe hrs: | 333 hours |
| Engine model: | Rotax 912 ULS |
| Fatalities: | Fatalities: 0 / Occupants: 1 |
| Aircraft damage: | Substantial |
| Category: | Accident |
| Location: | St. Augustine, Florida -
 United States of America
|
| Phase: | Initial climb |
| Nature: | Private |
| Departure airport: | St. Augustine Airport-Northeast Florida Regional Airport, FL (UST/KSGJ) |
| St. Augustine Airport-Northeast Florida Regional Airport, FL (UST/KSGJ) | |
| Investigating agency: | NTSB |
| Confidence Rating: |  Accident investigation report completed and information captured |
The accident flight was the first flight after the experimental light sport airplane's engine was removed and replaced. During initial climb, the engine experienced a partial power loss, followed by a total loss of power. During the emergency glide back to the airport, the airplane struck utility wires just prior to the runway. The wreckage was recovered and stored outside, unattended at the airport. Several weeks later, examination of the engine revealed no mechanical discrepancies that would have prevented normal operation. Following the examination, the engine was started and ran uninterrupted.
The airplane owner stated that during engine installation, the mechanic routed the carburetor vent lines upward and tie-wrapped them at the top of each carburetor. The owner further stated that someone must have tampered with the wreckage, as the carburetor vent lines were found routed downward when the engine examination was conducted. The owner subsequently provided a blurry photograph of the engine during installation, prior to the accident, which showed the carburetor vent lines routed upward and tie-wrapped. The engine manufacturer confirmed that upward routing of the lines into an area of positive static pressure could result in fuel starvation.
The mechanic stated that it did not matter if the carburetor vent lines were routed upward or downward and he could not remember which way he routed them on the accident airplane. He further stated that the installation manual did not specify if the lines should be routed upward or downward.
Review of Rotax installation manual excerpts, provided by the mechanic, revealed:
"15) Carburetor...CAUTION: The float chamber venting lines (3) lines have to be routed in a ram-air and vacuum free zone or into the airbox, according to the requirements and release of BRP-Rotax...These lines must not be routed into the slipstream or down the firewall...15.1.1) Drainage piping on airbox and drip trays...WARNING...Route the lines with a continuous decline."
A low fuel level was found in the carburetor float bowl and the mechanical fuel pump, which was consistent with a possible fuel issue that included incorrect carburetor vent hose routing as stated by the airplane owner.
Probable Cause: A total loss of engine power during initial climb for undetermined reasons.
Accident investigation:
 |
|
Sources:
NTSB ERA11LA079
Location
Revision history:
| Date/time | Contributor | Updates |
|---|---|---|
| 04-Oct-2022 16:29 | ASN Update Bot | Added |
Corrections or additions? ... Edit this accident description
The Aviation Safety Network is an exclusive service provided by:
Quick Links:
| ASN Home | Send Correction / Feedback |
| FSF Home | Disclaimer | Copyright |
| Contact Us | Privacy Policy |
| Press / Media |
CONNECT WITH US:
©2024 Flight Safety Foundation