ASN Wikibase Occurrence # 290064
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can submit corrected information.
| Date: | Thursday 2 May 2013 |
| Time: | 14:50 LT |
| Type: |  Robinson R44 II |
| Owner/operator: | Leading Edge Aviation |
| Registration: | N442RN |
| MSN: | 11047 |
| Year of manufacture: | 2006 |
| Total airframe hrs: | 1615 hours |
| Engine model: | Lycoming IO-540 |
| Fatalities: | Fatalities: 0 / Occupants: 1 |
| Aircraft damage: | Substantial |
| Category: | Accident |
| Location: | Pomeroy, Washington -
 United States of America
|
| Phase: | Standing |
| Nature: | Agricultural |
| Departure airport: | Pomeroy, WA |
| Pomeroy, WA | |
| Investigating agency: | NTSB |
| Confidence Rating: |  Accident investigation report completed and information captured |
Before the agricultural application flight, the pilot asked the ground crewman to refill the spray tank with 50 gallons of chemical solution; 10 gallons of aviation fuel was also added. Subsequently, the ground crewman signaled to the pilot that the helicopter was ready to depart. During the departure and while transitioning to forward flight, the low-rotor rpm horn activated, and the pilot immediately pushed the emergency dump button to lighten the load; however, the rpm continued to decrease, and the pilot initiated a run-on landing to a field. During the landing, the pilot was unable to maintain control as the left skid dug into the dirt, which resulted in the helicopter nosing over and coming to rest on its left side.
The pilot reported that he believed the amount of solution added to the tank was more than 50 gallons, which placed the helicopter outside of weight and balance and performance limitations. The pilot added that the spray tank sight glass is long and very shallow, and that, unless the helicopter is level, the sight glass reading is inaccurate. Additionally, when seated in the helicopter, it was not possible for the pilot to see the spray tank sight glass or know how much spray solution had been loaded into the tank. Therefore, the pilot had to rely either on the ground crewman or exit the helicopter after each load and visually check the load to ensure that the helicopter was loaded with the proper amount of chemical solution. The pilot reported no mechanical malfunctions or failures with the helicopter that would have precluded normal operation.
Probable Cause: The pilot's failure to ensure that the helicopter was properly loaded, which resulted in the helicopter being in excess of its maximum allowable gross weight and led to a loss of main rotor rpm on takeoff. Contributing to the accident were the ground crewman's inadvertent overloading of the helicopter and the design of the spray tank's visual sight glass, which did not allow the pilot to visually verify the amount of the spray tank load without exiting the helicopter.
Accident investigation:
 |
|
Sources:
NTSB WPR13LA217
Location
Revision history:
| Date/time | Contributor | Updates |
|---|---|---|
| 06-Oct-2022 07:44 | ASN Update Bot | Added |
Corrections or additions? ... Edit this accident description
The Aviation Safety Network is an exclusive service provided by:
Quick Links:
| ASN Home | Send Correction / Feedback |
| FSF Home | Disclaimer | Copyright |
| Contact Us | Privacy Policy |
| Press / Media |
CONNECT WITH US:
©2024 Flight Safety Foundation