ASN Wikibase Occurrence # 291482
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can
submit corrected information.
Date: | Wednesday 2 March 2016 |
Time: | 10:30 LT |
Type: | Bell 47G |
Owner/operator: | Private |
Registration: | N568TB |
MSN: | 85 |
Year of manufacture: | 1948 |
Total airframe hrs: | 5818 hours |
Engine model: | Lycoming VO435A1F |
Fatalities: | Fatalities: 0 / Occupants: 1 |
Aircraft damage: | Substantial |
Category: | Accident |
Location: | Agua Dulce, California -
United States of America
|
Phase: | En route |
Nature: | Private |
Departure airport: | Lancaster-William J Fox Airport, CA (WJF/KWJF) |
Destination airport: | AGUA DULCE, CA (L70) |
Investigating agency: | NTSB |
Confidence Rating: | Accident investigation report completed and information captured |
Narrative:The helicopter pilot reported that while flying about 300 feet above a ridge with an elevation of 4,900 feet at 10 miles per hour (8.68 knots), he could not hear very well in his headset and needed to adjust the volume. He reported that he removed his left hand from the collective and used it to hold the cyclic so he could use his right hand to adjust the volume on his headset. During this process, he reported that he forgot to increase the friction on the collective prior to removing his left hand. He further reported that the collective "dropped which decreased main rotor pitch causing the engine to overspeed."
The pilot reported that the helicopter started to spin to the right; he grabbed the collective, reduced throttle, and then increased the collective pitch. He reported that the helicopter "experienced settling with power," and spun around 8 to 10 times. He further reported that the helicopter landed hard at the top of a ridge and rolled onto its right side. The helicopter sustained substantial damage to the fuselage, main rotor system, tailboom, and tail rotor system.
The pilot verified that there were no preimpact mechanical failures or malfunctions with the airframe or engine that would have precluded normal operation.
As a safety recommendation, the pilot stated he "should have increased the collective friction prior to removing his left hand from the collective stick." He also stated that "the problem was made worse because the helicopter was only 300 feet above ground level at 10 miles per hour [8.68 knots]."
The Federal Aviation Administration (FAA) has published FAA-H-8083-21 Helicopter Flying Handbook (2012). This handbook discusses the function of the collective and states in part:
"An adjustable friction control helps prevent inadvertent collective pitch movement."
This handbook also discusses recovery from a settling with power condition and states in part:
"When recovering from a settling with power condition, the pilot tends first to try to stop the descent by increasing collective pitch. However, this only results in increasing the stalled area of the rotor, thereby increasing the rate of descent. Since inboard portions of the blades are stalled, cyclic control may be limited. Recovery is accomplished by increasing airspeed, and/or partially lowering collective pitch. In many helicopters, lateral cyclic combined with lateral tail rotor thrust will produce the quickest exit from the hazard assuming that there are no barriers in that direction. In a fully developed vortex ring state, the only recovery may be to enter autorotation to break the vortex ring state."
The pilot reported that he utilized a 4-point restraint system installed in the helicopter and sustained minor injuries. He also reported that "I credit the shoulder harness restraint with keeping my injuries from being far worse."
Probable Cause: The pilot's failure to set the appropriate collective friction prior to releasing the collective in flight, which resulted in decreased main rotor pitch, settling with power, and an impact with terrain.
Accident investigation:
|
| |
Investigating agency: | NTSB |
Report number: | GAA16CA143 |
Status: | Investigation completed |
Duration: | 1 month |
Download report: | Final report |
|
Sources:
NTSB GAA16CA143
History of this aircraft
Other occurrences involving this aircraft Location
Revision history:
Date/time | Contributor | Updates |
07-Oct-2022 14:25 |
ASN Update Bot |
Added |
The Aviation Safety Network is an exclusive service provided by:
CONNECT WITH US:
©2024 Flight Safety Foundation