ASN Wikibase Occurrence # 293022
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can
submit corrected information.
Date: | Wednesday 21 September 2005 |
Time: | 18:00 LT |
Type: | Cessna 180H |
Owner/operator: | Private |
Registration: | N1037V |
MSN: | 18051989 |
Year of manufacture: | 1968 |
Engine model: | Continental O-470-R |
Fatalities: | Fatalities: 0 / Occupants: 1 |
Aircraft damage: | Substantial |
Category: | Accident |
Location: | Yelm, Washington -
United States of America
|
Phase: | Unknown |
Nature: | Private |
Departure airport: | Yelm, WA |
Destination airport: | Spanaway, WA (S44) |
Investigating agency: | NTSB |
Confidence Rating: | Accident investigation report completed and information captured |
Narrative:The pilot reported that he had a hard time starting the engine. Thinking that it was still hot from the previous flight, he pulled the mixture to lean and the engine eventually started. The pilot then put the mixture control to the rich position. The engine run-up was accomplished prior to takeoff with no abnormalities noted. The pilot stated that after takeoff, at about 200 feet above ground level, the engine lost power. The pilot initiated a turn to an open field and pumped the throttle, then the mixture control. The engine started momentarily before losing power again. The pilot then landed the aircraft in an open field. During the landing roll, the aircraft collided with several fences. Post accident inspection of the engine by a local Inspection Authorization mechanic found that the retaining nut and washer on the mixture cable attach bolt was missing. The mechanic operated the mixture cable and found that the lever on the carburetor did not move stop-to-stop. When operating the mixture stop-to-stop from the pilot's seat, the lever on the carburetor slipped and would not stay in preset position in relation to the mixture cable. Further inspection of the engine did not find any other mechanical failures or malfunctions that would preclude the engine from running. An annual inspection had been accomplished about 27 hours prior to the accident.
Probable Cause: The mixture control linkage separation as a result of a missing retaining nut and washer on the mixture cable attach bolt. Inadequate maintenance inspection and fences were factors.
Accident investigation:
|
| |
Investigating agency: | NTSB |
Report number: | SEA05CA197 |
Status: | Investigation completed |
Duration: | 4 months |
Download report: | Final report |
|
Sources:
NTSB SEA05CA197
Revision history:
Date/time | Contributor | Updates |
09-Oct-2022 15:04 |
ASN Update Bot |
Added |
The Aviation Safety Network is an exclusive service provided by:
CONNECT WITH US:
©2024 Flight Safety Foundation