ASN Wikibase Occurrence # 295707
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can submit corrected information.
| Date: | Saturday 14 June 2003 |
| Time: | 08:30 LT |
| Type: | Kolb Company MKIII |
| Owner/operator: | Private |
| Registration: | UNREG |
| MSN: | 035 |
| Fatalities: | Fatalities: 0 / Occupants: 1 |
| Aircraft damage: | Substantial |
| Category: | Accident |
| Location: | Bunnell, Florida -
 United States of America
|
| Phase: | Unknown |
| Nature: | Test |
| Departure airport: | Bunnell, FL (X47) |
| Bunnell, FL (X47) | |
| Investigating agency: | NTSB |
| Confidence Rating: |  Accident investigation report completed and information captured |
The pilot stated that prior to the flight, the horizontal stabilizers which had been folded up were extended. He attached the lower elevator flight control cables and performed a preflight inspection of the airplane; he does not have a preflight checklist. Following the preflight, he started the engine and taxied to runway 24, and after landing traffic cleared the runway, he taxied onto the runway and applied power to takeoff. The airplane became airborne and when the flight was approximately 15 to 20 feet above ground level, he heard a "boom" sound, and experienced an immediate loss of elevator control. The airplane began a right turn and pitched nosed down. He reduced throttle to idle, and the airplane impacted the ground between runways 24 and 27. He later stated the leading edge of the right horizontal stabilizer rotated up 90 degrees. Each horizontal stabilizer (stabilizer) is structurally attached to the boom tube at the front and rear of each stabilizer. Additionally, a flying wire attaches to the top and bottom of each stabilizer. The front of each stabilizer is secured to the boom tube by a clevis and a safety pin which secures through a u-shaped bracket on the boom tube and a mating fitting on the stabilizer. The rear of each stabilizer is secured to the boom tube by a 1/4 inch diameter bolt and self locking nut which goes through a hinge. According to the pilot, postaccident the forward clevis pin and safety pin of the right stabilizer was not located. The upper and lower flying wires of the right stabilizer were not failed, and the 1/4 inch diameter bolt of the aft attach point was in-place.
Probable Cause: The inadequate preflight inspection of the airplane by the pilot-in-command (pilot) for his failure to assure that the forward attachment of the right horizontal stabilizer was secured and safetied before flight resulting in rotation of the leading edge of the right horizontal stabilizer and in-flight loss of control.
Accident investigation:
 |
|
Sources:
NTSB MIA03CA128
Revision history:
| Date/time | Contributor | Updates |
|---|---|---|
| 13-Oct-2022 11:54 | ASN Update Bot | Added |
Corrections or additions? ... Edit this accident description
The Aviation Safety Network is an exclusive service provided by:
Quick Links:
| ASN Home | Send Correction / Feedback |
| FSF Home | Disclaimer | Copyright |
| Contact Us | Privacy Policy |
| Press / Media |
CONNECT WITH US:
©2024 Flight Safety Foundation