ASN Wikibase Occurrence # 370542
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information.
If you feel this information is incomplete or incorrect, you can
submit corrected information.
Date: | Saturday 16 September 2000 |
Time: | 20:25 LT |
Type: | Beechcraft 1900C |
Owner/operator: | Gulfstream International |
Registration: | N194GA |
MSN: | UB-8 |
Year of manufacture: | 1984 |
Total airframe hrs: | 31387 hours |
Engine model: | P&W PT6A-65B |
Fatalities: | Fatalities: 0 / Occupants: 12 |
Aircraft damage: | Minor |
Category: | Serious incident |
Location: | Miami International Airport, FL (MIA/KMIA) -
United States of America
|
Phase: | Landing |
Nature: | Unknown |
Departure airport: | FREEPORT, OF (MYGF) |
Destination airport: | Miami International Airport, FL (MIA/KMIA) |
Investigating agency: | NTSB |
Confidence Rating: | Accident investigation report completed and information captured |
Narrative:After takeoff, both main gears remained down and locked; the nose gear was in-transit. Attempts to lock the nose gear were unsuccessful; the nose gear collapsed during the landing roll. The emergency hand pump was unable to build pressure in secondary system due to leakage past the shuttle valve and the shuttle bore in the end cap of the left gear actuator; excessive clearance was noted. The shuttle valve or bore were not worn or damaged. During manufacturing, the shuttle bore and shuttle valve are honed and lapped to fit and kept as matching parts; clearance limits are not specified. Functional testing detects excessive clearance. Overhaul procedures do not require honing of the shuttle bore. The power pack motor was inoperative with a "load" applied. The left actuator was overhauled August 1998; during overhaul the shuttle and end cap were not replaced. The overhauled actuator was installed February 2000. Emergency extension and rigging checks required by the airline job card and maintenance manual respectively were not performed following actuator installation. Emergency extension check was accomplished last approximately 4 months earlier; the maintenance manual does not indicate application of force to the tires during extension check using the emergency hand pump. The airplane had accumulated approximately 1,475 hours and 1,746 cycles since actuator installation and 18,302 hours and 23,315 cycles since power pack assembly installation.
Probable Cause: The excessive clearance between the shuttle valve and the shuttle bore in the end cap of the left main landing gear actuator for undetermined reasons either during overhaul or manufacturing resulting in failure to build hydraulic pressure using the emergency hand pump. A finding in the investigation was the failure of the airplane manufacturer to identify procedures in the maintenance manual that would detect the above listed condition during check of the emergency hand pump.
Accident investigation:
|
| |
Investigating agency: | NTSB |
Report number: | MIA00IA266 |
Status: | Investigation completed |
Duration: | 1 year 1 month |
Download report: | Final report |
|
Sources:
NTSB MIA00IA266
Location
Revision history:
Date/time | Contributor | Updates |
25-Mar-2024 11:46 |
ASN Update Bot |
Added |
The Aviation Safety Network is an exclusive service provided by:
CONNECT WITH US:
©2024 Flight Safety Foundation