Accident Robinson R22 Beta N7512G,
ASN logo
ASN Wikibase Occurrence # 44195
 
This information is added by users of ASN. Neither ASN nor the Flight Safety Foundation are responsible for the completeness or correctness of this information. If you feel this information is incomplete or incorrect, you can submit corrected information.

Date:Wednesday 22 February 2006
Time:11:35
Type:Silhouette image of generic R22 model; specific model in this crash may look slightly different    
Robinson R22 Beta
Owner/operator:All Out Aerial
Registration: N7512G
MSN: 3315
Year of manufacture:2002
Total airframe hrs:563 hours
Engine model:Lycoming O-360-J2A
Fatalities:Fatalities: 2 / Occupants: 2
Aircraft damage: Destroyed
Category:Accident
Location:near East Lariat Lane, 8 miles N of Scottsdale, Arizona -   United States of America
Phase: En route
Nature:Training
Departure airport:Scottsdale, AZ (SDL)
Destination airport:
Investigating agency: NTSB
Confidence Rating: Accident investigation report completed and information captured
Narrative:
The certificated helicopter flight instructor was conducting an introductory flight instruction lesson under Title 14, CFR part 91 with a prospective student. A witness, about 1 mile south of the accident site, estimated that the helicopter was about 1,000 feet above the ground as it passed over him. Shortly afterwards, he heard a "pop", and the helicopter started a shallow, controlled turn to the left, followed by two or three more popping sounds. The helicopter then began to descend rapidly, and started spinning counter-clockwise. As the helicopter's descent rate increased, the main rotor blades stopped turning, and the helicopter entered a vertical descent. The witness said he could no longer hear any engine sounds during the accident helicopter's vertical descent. The helicopter crashed in a residential area, and came to rest between two houses. The helicopter sustained damage consistent with a high speed, fuselage level, vertical impact. Postaccident inspection of the engine core and airframe disclosed no evidence of any preimpact anomalies. Impact damage prevented testing of the engine's carburetor and ignition wiring harness assemblies. A review of the accident pilot's historical training records revealed a series of failed check rides and overall substandard performance. The NTSB IIC interviewed both previous and prospective employers, which disclosed that the accident pilot had either been dismissed or not hired due to his lack of academic and/or flight skills. The FAA approved flight manual for the accident helicopter, emergency procedures section, states that at the first indication of an engine failure, the pilot's required emergency action is, in part: 1) Lower collective immediately to maintain rotor rpm, and enter a normal autorotation. 2) Establish a steady glide at approximately 65 knots. The helicopter manufacturer published a safety notice, which addressed the dangers of a low rotor rpm conditions, stating in part: "A primary cause of fatal accidents in light helicopters is the [pilots] failure to maintain rotor rpm. To avoid this, every pilot must have his reflexes conditioned so he will instantly add throttle and lower the collective to maintain rpm in any emergency." Additionally, the safety notice states, in part: "If the pilot not only fails to lower the collective, but instead pulls up on the collective to keep the ship [helicopter] from going down, the rotor will stall almost immediately. When it stalls, the blades will either "blow back" and cut off the tail cone or it will just stop flying, allowing the helicopter to fall at an extreme rate. In either case, the resulting crash is likely to be fatal. No matter what causes the low rotor rpm, the pilot must first roll on the throttle and lower the collective simultaneously to recover rpm BEFORE investigating the problem. It must be a conditioned reflex. In forward flight, applying aft cyclic to bleed off airspeed will also help recover lost [rotor] rpm."


Probable Cause: A loss of engine power during cruise flight for an undetermined reason, and the pilot's failure to maintain rotor rpm, which resulted in an uncontrolled descent and collision with terrain.

Accident investigation:
cover
  
Investigating agency: NTSB
Report number: ANC06FA020
Status: Investigation completed
Duration:
Download report: Final report

Sources:

NTSB: https://www.ntsb.gov/_layouts/ntsb.aviation/brief.aspx?ev_id=20060228X00255&key=1
FAA register: 2. FAA: http://registry.faa.gov/aircraftinquiry/NNum_Results.aspx?NNumbertxt=7512G

Location

Revision history:

Date/timeContributorUpdates
28-Oct-2008 00:45 ASN archive Added
29-Sep-2016 18:35 Dr.John Smith Updated [Time, Location, Departure airport, Destination airport, Source, Narrative]
29-Sep-2016 18:35 Dr.John Smith Updated [Aircraft type]
21-Dec-2016 19:24 ASN Update Bot Updated [Time, Damage, Category, Investigating agency]
05-Dec-2017 09:02 ASN Update Bot Updated [Other fatalities, Departure airport, Destination airport, Source, Narrative]

Corrections or additions? ... Edit this accident description

The Aviation Safety Network is an exclusive service provided by:
Quick Links:

CONNECT WITH US: FSF on social media FSF Facebook FSF Twitter FSF Youtube FSF LinkedIn FSF Instagram

©2024 Flight Safety Foundation

1920 Ballenger Av, 4th Fl.
Alexandria, Virginia 22314
www.FlightSafety.org